ISO INTERNATIONAL STANDARD 12176-3 Third edition 2011-02-15 Plastics pipes and fittings Equipment for fusion jointing polyethylene systems Part 3: Operator's badge Tubes et raccords en matieres plastiques - Appareillage pour I'assemblagepar soudage des systemes enpolyethylene Partie 3: Carte d'identification de I'opérateur Reference number ISO 12176-3:2011(E) @ ISO 2011 IHS unde Not for Resale ISO 12176-3:2011(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISo's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IsO 2011 - All rights reserved without license from IHS Not for Resale ISO 12176-3:2011(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (lsOmemberbodies).TheworkofpreparingInternationalStandardsisnormallycarriedoutthroughIso International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. adoptedbythetechnicalcommitteesarecirculatedtothememberbodiesforvoting.Publicationasan International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 12176-3 was prepared by Technical Committee ISO/TC 138, Plastics pipes, fittings and valves for the revision. fusion jointingpolyethylene systems: Part 1: Butt fusion Part 2: Electrofusion Part 3: Operator's badge Part 4:Traceabilitycoding onal organization frstandardizalin'ghts reserved ili