ISO/TS TECHNICAL SPECIFICATION 13399-302 First edition 2013-10-15 Cutting tool data representation and exchange - Part 302: Concept for the design of 3D models based on properties according to IsO/ TS 13399-3: Modelling of solid drills and countersinking tools Représentation et échange des données relatives aux outils coupants Partie 302: Description des modeles 3D bases sur les propriétes de I'IS0/ TS 13399-3: Modelisation des forets monoblocs et des outils de lamage Reference number IS0/TS13399-302:2013(E) LSO CopyrightInternationalOrganizationfor Standardization @ IS0 2013 t license from IHS Not for Resale IS0/TS13399-302:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permitted without license from IHS Not for Resale IS0/TS13399-302:2013(E) Contents Page Foreword ..V Introduction. ..vii 1 Scope. 2 Normative references ..1 3 Starting elements, coordinate systems, planes 3.1 General. .1 3.2 Reference system 3.3 Coordinate system at the cutting part .2 3.4 McScoordinatesystem. 3.5 Planes 4 3.6 Cutting reference point (CRP) .4 4 Design of the model. ..5 4.1 General 4.2 Necessary parameters for the connection interface feature ..6 5 Twist drill ..6 5.1 General .6 5.2 Necessary properties. ..7 5.3 Geometry of the non-cutting part including the connection. 5.4 Geometry of the cutting part. ..8 5.5 Twist drill Complete. 6 Step drill .10 6.1 General .10 6.2 Necessary properties. .10 6.3 Geometry of the non-cutting part including the connection. ..11 6.4 Geometry of the cutting part. .11 6.5 Step drill - Complete .12 7 Core drill ..12 7.1 General. .12 7.2 Necessary properties. .13 7.3 Geometry of the non-cutting part including the connection. ..14 7.4 Geometry of the cutting part. .14 7.5 Core drill Complete ..15 8 Counterbore ..15 8.1 General .15 8.2 Necessary properties. .16 8.3 Geometry of the non-cutting part including the connection .16 8.4 Geometry of the cutting part. ..16 8.5 Counterbore Complete ..17 9 Stepped countersinking tool or tapered countersinking tool ..18 9.1 General ..18 9.2 Necessary properties. 19 9.3 Geometry of the non-cutting part including the connection .20 9.4 Geometryofthecuttingpart 20 9.5 Stepped or tapered countersinking tool - Complete ..22 10 Spot drill. .23 10.1 General 23 10.2 Necessary properties. 23 10.3 Geometry of the non-cutting part including the connection. .24 10.4 Geometry of the cutting part. 24 10.5 Spot drili - Complete .25 iii ense with ISt ed without license from IHS Not for Resale